Homa Collet Impeller Disassembly and Installation Manual de usuario descargar pdf (Pagina 2)

Publication

88FN2010

Please Contact

Technical Support At 203

736

8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

2 of 3

Assembly

• Place o-ring around outside diameter and

inside diameter of distance ring, lubricate with

liquid soap, and place in impeller.(D).DO NOT

USE GREASE TO LUBRICATE.

• Lightly tap ring in with a plastic hammer.

• Loosen all screws in impeller locking

mechanism, and pull the opposite sides to

extend the mechanism. (E)

•

Degrease inside and outside surface of locking

mechanism, shaft, and impeller borehole. Any

residual on these surfaces may cause collet to

slip.

• Place locking mechanism into impeller

borehole. (F)

• Lubricate inner o-ring in distance ring with

liquid soap.

• Slide impeller onto shaft until locking

mechanism reaches shoulder of the shaft.

• Be certain that the locking mechanism stays in

the proper position while installing on shaft.

1 2 3

Sin comentarios

Homa Collet Impeller Disassembly and Installation Manual de usuario Pagina 2